Emulex LP1005DC-CM2 Bedienungsanleitung PDF herunterladen (Seite 96)

Driver for Linux - Configuration Section Page 90

Reassign a Backup Master as the New MSC from the Old MSC

Because a Backup Master may have to take over as the Master Security Client (MSC), it should be able

to physically access all of the HBAs that the MSC can access. If the MSC is connected to multiple

fabrics, its Backup Master should be selected from the Available Systems list that is connected to the

same fabrics as the MSC.

To reassign a Backup Master as the new MSC from the old MSC:

1. On the MSC, start the HBAnyware Security Configurator.

2. Click the Backup Master tab.

Figure 58: The Backup Master Tab

3. In the Backup Masters list, select the Backup Master system that you want to reassign as the

MSC.

4. Click Assign New Master Client. You will be asked if you wish to proceed.

5. Click Yes. The selected Backup Master becomes the new MSC. The current MSC becomes a

server in the new MSC's ACG. After the changes are made, a message indicates that the

reassignment is complete.

6. Click OK. The Configurator closes because the system is no longer the MSC.

Reassign a Backup Master as the New MSC from the Backup Master

To reassign a Backup Master as the new MSC from the Backup Master:

1. On the Backup Master system that you want to reassign as the MSC, start the HBAnyware

Security Configurator.

WARNING: Use this method only if the MSC cannot relinquish control to a Backup Master. For

example, if the MSC is no longer bootable or able to connect to the Fibre Channel network.

Under any other circumstances, if the Backup Master takes over as the MSC, and the MSC

is still running or comes back online later, there will be two MSCs for the same security

configuration. This will eventually lead to corruption of the security configuration.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 161 162

Keine Kommentare

Emulex LP1005DC-CM2 Bedienungsanleitung Seite 96