Emulex LP1005DC-CM2 Bedienungsanleitung PDF herunterladen (Seite 74)

Driver for Linux - Configuration Section Page 68

4. Target mappings are displayed by world wide port name (WWPN), world wide node name

(WWNN), device ID (D_ID), SCSI ID, or Type. This can be either 'PB', indicating that the

mapping was the result of a persistent binding, or 'Auto', indicating that the target was

automapped. In the Display Mode section, choose the display mode you want to use.

5. If you want to change the Active Bind Type (the mode used to persistently bind target mappings)

or Automapping setting, click Change Settings. Select the Bind Type (WWPN, WWNN or

D_ID), and set Automapping to Enabled or Disabled.

Add Persistent Binding

To add a persistent binding:

1. In the Targets Table, click the target that you want to bind.

2. Click Add Binding. The Add Persistent Binding dialog box is displayed.

Figure 31: The HBAnyware Add Persistent Binding Dialog Box

Note: All mapped targets, whether automapped or resulting from a persistent binding

configuration, will have entries in the “Current Mappings” table on the Target

Mapping dialog box.

If the binding that you defined has been successfully activated, you will see following

message:

“The new binding has been created and is currently active. Please note, however,

that the binding will not become permanently registered until after you have

recompiled the driver.”

Remember, if you reboot the sytsem or stop/restart the driver, the binding will

become inactive. To make the binding "stick" over subsequent reboots or driver

restarts, you must recompile the driver.

If, however, the binding was successfully created, but could not be made active, you

will see the following message:

“The new binding has been created. Note that this binding will not become active

until after you have recompiled and reloaded the lpfc driver.” Generally, you should

ensure that the bind type in the Current Settings section of the Target Mapping

dialog box is the same as the type of binding selected in the Persistent Binding

Configuration section of the dialog box.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 161 162

Keine Kommentare

Emulex LP1005DC-CM2 Bedienungsanleitung Seite 74