Emulex LP1005DC-CM2 Bedienungsanleitung PDF herunterladen (Seite 101)

Driver for Linux -Troubleshooting Section Page 95

Cannot See Other HBAs or Hosts.

Although HBAnyware is installed, only local

host bus adapters (HBAs) are visible. The

other HBAs and hosts in the SAN cannot be

seen.

HBAnyware uses in-band data communication, meaning that

the management server running HBAnyware must have a

physical Fibre Channel connection to the SAN. All the HBAs in

the SAN will be visible if:

• The other servers have a Fibre Channel connection to your

zone of the SAN. Check fabric zoning.

• Ensure that rmserver processes are running on remote hosts

(For Linux/Solaris systems, enter ps -ef | grep rmserver).

• All other HBAs are running HBAnyware and the appropriate

driver.

• The other HBAs are Emulex HBAs.

Note: HBAnyware must be running on all remote hosts that are

to be discovered and managed.Remote capabilities of

HBAnyware are subject to fabric zoning configuration.

Remote hosts to be discovered and managed by

HBAnyware must be in the same zone.

Cannot See Multiple Zones from the

Management Server. Cannot see multiple

zones on the same screen of my

management server running HBAnyware.

Provide a physical Fibre Channel connection into each of the

zones. For each zone you want to see, connect an Emulex

HBAnyware enabled port into that zone.

SAN Management Workstation Does Not

Have a Fibre Channel Connection. The

SAN management workstation does not

have a physical Fibre Channel connection

into the SAN because the other management

tools are all out-of-band. Can HBAnyware be

run on this SAN management workstation?

From the SAN management workstation, run a terminal

emulation session into one of the servers that has HBAnyware

loaded on it. Open an X-Windows session to run the server's

HBAnyware GUI remotely.

Cannot See New LUNs. Although new

LUNs were created on the storage array,

they do not appear in HBAnyware.

• Refresh the screen.

• Exit HBAnyware and restart HBAnyware. If new LUNs are

visible, you are finished. If that doesn't work, try the following:

1. Exit HBAnyware.

2. Navigate to /usr/sbin/hbanyware.

3. Run ./stop_hbanyware to stop both the rmserver and

elxdiscovery processes.

4. Run ./start_rmserver and ./start_elxdiscovery to restart

both processes.

HBAnyware Appears on Remote Servers

in the SAN.

To prevent HBAnyware from appearing on remote servers in the

SAN, do one of the following:

Disable the rmserver process:

1. Navigate to /usr/sbin/hbanyware.

2. Run ./stop_hbanyware to stop both the rmserver and

elxdiscovery processes.

3. Run ./start_rmserver and ./start_elxdiscovery to

restart both processes.

Disabling this service or process prevents the local servers from

being seen remotely.

Table 3: General Situations (Continued)

Situation Resolution

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 161 162

Kommentare zu diesen Handbüchern

Keine Kommentare

Emulex LP1005DC-CM2 Bedienungsanleitung Seite 101

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Emulex LP1005DC-CM2