Emulex LP1005DC-CM2 Bedienungsanleitung PDF herunterladen (Seite 107)

Driver for Linux -Troubleshooting Section Page 101

Non-Hierarchical and Hierarchical ASG

It is possible from a higher-level client (such as the MSC) to create an ASG 1 with system A as the client

and systems B, C, D, and E as servers. Then create an ASG 2 with system E as the client, but with

systems F and G as servers even though F and G are not part of ASG 1. This makes the topology non-

hierarchical (see Figure 60).

Figure 60: Non-hierarchical ASG Scenario

System E is part of ASG 1, but has been made a client of ASG 2, and both of the servers in ASG 2 are

not part of ASG 1. You could not create this ASG on system A, but you could on the MSC (or on a parent

client) because it can access systems F and G. Although not shown in the picture, it is also possible to

make system A a server in ASG 2, creating a case where system A and system E are both clients and

servers to/of each other.

While the Security Configurator will allow you to set up ASGs this way, it is best not to create a topology

like this as it can lead to confusion. The best way is to set up the ASG on the MSC (or a higher-level

parent) where the clients and servers do not cross over into other ASGs. Then set up ASGs on clients of

those ASGs in the same manner, keeping the topology hierarchical (see Figure 61)

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 161 162

Keine Kommentare

Emulex LP1005DC-CM2 Bedienungsanleitung Seite 107