Emulex LP1005DC-CM2 Bedienungsanleitung PDF herunterladen (Seite 46)

Driver for Linux - Configuration Section Page 40

• Change Settings - click to change the Bind Type, the mode used to persistently bind target

mappings. The Mapped Target Settings window is displayed. Select the Bind Type (WWPN,

WWNN, or D_ID) or set Automapping to Enabled to Disabled.

• Add Binding - click to add a persistent binding.

• Bind New Target - click to add a target that does not appear in the Persistent Binding table.

• Remove - click to remove the selected binding.

• Remove All Bindings - click to remove all persistent bindings that are displayed.

View Driver Parameters

The Driver Parameters tab allows you to modify driver parameters either for an individual adapter or for all

adapters, with the same single driver type and version, that are in one host.

For example, if you set driver parameters on a host that includes two adapters, you can make changes to

the driver parameters for both adapters simultaneously using the Host Driver Parameters tab.

For each parameter, the tab displays the current value, the range of acceptable values, the default value,

and whether the parameter is dynamic (a dynamic parameter allows the change to take effect without

restarting the HBA or rebooting the system).

To display the driver parameters for an HBA:

1. Do one of the following:

• From the menu bar, click View, then click Group HBAs by Host Name.

• From the toolbar, click the button.

2. In the discovery tree, click the HBA. The General tab is displayed.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 161 162

Keine Kommentare

Emulex LP1005DC-CM2 Bedienungsanleitung Seite 46