Emulex LP1005DC-CM2 Bedienungsanleitung PDF herunterladen (Seite 48)

Driver for Linux - Configuration Section Page 42

3. Click the Host Driver Parameters tab (Figure 19). The Installed Driver Types drop-down box

displays a list of all driver types and driver versions that are installed on the adapters in the host.

Figure 19: The HBAnyware, Host Driver Parameters Tab

Driver Parameter Tab Field Definitions

• Installed Driver Type - current driver and version installed.

• Adapter Parameter table - a list of parameters and their current values.

• Parameter-specific information - details about the parameter appears on the right side of the tab.

Driver Parameter Tab Buttons

• Restore - click to save and restore parameters to this last saved value, if you have made

changes to parameters and have not saved them by clicking Apply.

• Defaults - click to reset all parameter values to their default (out-of-box) values.

• Apply - click to apply any driver parameter changes. If you changed a parameter that is not

dynamic, you must unload the driver, recompile it, then reload it.

To change non-dynamic parameters (Permanently):

1. Navigate to the /usr/sbin/hbanyware directory and run the scripts to stop HBAnyware processes.

Type

./stop_hbanyware

2. Unload the lpfcdfc driver. Type:

rmmod lpfcdfc

3. Unload the lpfc driver. Type:

rmmod lpfc

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 161 162

Keine Kommentare

Emulex LP1005DC-CM2 Bedienungsanleitung Seite 48