Emulex LP1005DC-CM2 Bedienungsanleitung PDF herunterladen (Seite 8)

Driver for Linux - Installation Section Page 2

Compatibility

• LPe11000, LPe11002 and LPe1150 (minimum firmware version 2.50a2)

• LP11000, LP11002 and LP1150 (minimum firmware version 2.10a5)

• LP1005DC-CM2 (minimum firmware version 1.90a5)

• LP10000ExDC and LP1050Ex (minimum firmware version 1.90a4)

• LP10000DC and LP10000 (minimum firmware version 1.90a4)

• LP1050DC and LP1050 (minimum firmware version 1.90a4)

• LP9802DC (minimum firmware version 1.90a4)

• LP9802 (minimum firmware version 1.90a4)

• LP982 (minimum firmware version 1.90a4)

• LP9402DC, LP9002DC, LP9002L and LP9000 (minimum firmware version 3.90a7)

• LP952L (minimum firmware version 3.92a2)

• LP8000 and LP8000DC

• If your HBA has a Dragonfly chip version 2.00 or greater, use firmware version 3.90a7.

• If your HBA has a Dragonfly chip below version 2.00, use firmware version 3.30a7.

Refer to the LP8000 and LP8000DC Firmware Download page on the Emulex website to deter-

mine the Dragonfly chip version in use.

Things to Know Before You Download

• Select a device driver download if you are updating an existing driver on your hard drive, or you

want to install the driver on your hard drive.

Known Issues

• FCP – Discovering Disk Drives. To list all the SCSI devices discovered at boot time, enter this

command:

cat /proc/scsi/scsi

• When running lspci or kudzu utilities, you may see the Emulex FC Host Adapter LP1005DC-

CM2 reported as the Emulex FC Host Adapter LP1050DC for the pci_id address f0a5. This is

due to a delay in getting the pci_id tables updated in the SourceForge upstream kernel.

• Although the driver recognizes disk drives at boot time, you may not be able to use those drives

until special file entries are created for them. By default, Linux provides special fields for up to

16 SCSI devices. With the Emulex driver, targets 1 through 255 are supported, with up to 128

LUNs per target. To create additional special files, use the ‘MAKEDEV’ command in the /dev

directory.

• If you are using a device driver download, you must first have a SCSI or IDE boot/root device in

order to create a Fibre Channel (lpfc) boot device.

Note: All SCSI device files are created if you are using SuSE SLES 8.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 161 162

Keine Kommentare

Emulex LP1005DC-CM2 Bedienungsanleitung Seite 8