Emulex LP1005DC-CM2 Bedienungsanleitung PDF herunterladen (Seite 108)

Driver for Linux -Troubleshooting Section Page 102

Figure 61: Hierarchical ASG Scenario

lpfc Log Messages

Introducton

Log messages are organized into logical groups based on code functionality within the Fibre Channel

driver. Each group consists of a block of 100 log message numbers. Most groups require a single block

of 100 message numbers, however some groups (INIT, FCP) require two blocks.

The groups and the associated number ranges are defined in the Message Log table below. The

preamble string shown in the Message Log table is displayed as part of the log message. The lower

case 'x' of the preamble string defines the severity of the log message. The 'x' will be replaced by one of

five lower case letters. Those letters are defined in the Severity Code table.

Severity Codes

Information and warning messages can be turned ON or OFF by setting/resetting the appropriate mask

bit(s) in the variable 'lpfc_log_verbose' located in the driver configuration module, lpfc.conf.c. By default,

both information and warning messages are disabled. Configuration error (c), error (e), and panic (p)

messages can not be disabled.

Table 9: Severity Code Table

Code Severity

i Information

w Warning

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 161 162

Keine Kommentare

Emulex LP1005DC-CM2 Bedienungsanleitung Seite 108