Emulex 110 Installationsanleitung PDF herunterladen (Seite 75)

Booting from the external storage array

Installation and Configuration

27. Select 1 (Scan Targets) to instruct the adapter to scan for attached

targets, and press Enter.

This displays a window similar to Figure 58.

Figure 58 Targets

IMPORTANT

If booting from Symmetrix with volume logix enabled, do not

select LUN 0, as this LUN is reserved for internal Symmetrix

use.

28. Select the number that corresponds to the array target port from

which the boot will be configured, and press Enter.

This displays a window similar to Figure 59 on page 76.

In Figure 58, the array designated by 002: DID:2C1900

WWN:5006048A CD201641 is the array from which the boot will

be configured.

Note: If no target numbers appear, and the utility simply returns

to the prior screen, verify the following:

• If multiple adapters are present, verify the adapter selected in the

BIOS utility is the same adapter that currently provides the I/O path

to the storage. (At this point, only one I/O path should be configured

to the boot LUN.)

• For VNX series or CLARiiON systems, verify the single I/O path

points to the SP that owns the boot LUN.

• For FC-SW environments, verify fabric-zoning parameters, such that

a single I/O path exists to the boot LUN. (Refer to your array

software documentation for details.)

• Check the physical Fibre Channel connectivity between the adapter

and array (direct-attach environment) or switch (FC-SW

environment).

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 239 240

Keine Kommentare

Emulex 110 Installationsanleitung Seite 75