Emulex 110 Installationsanleitung PDF herunterladen (Seite 208)

208

EMC Host Connecivity with Emulex Fibre Channel HBAs and CNAs in the Windows Environment

Miscellaneous Planning and Procedures

Table 4 shows the preconfigured settings. EMC recommends not

changing the values of these parameters from their default

settings unless it is necessary.

a. Driver version 2.01a0 and later requires this value to be set to 255 in order to

see 256 LUNs (LUN 0 through LUN 255).

Timer values that can be changed are located under the Tuning

menu at the top of the configuration tool window. By

highlighting an adapter from the Available Adapters list and

selecting the Timers option from the Tuning menu, the following

window appears.

Note: EMC recommends using the configuration menu to set these

values.

Table 4 Preconfigured settings

Adapter Controls

Automatically Map SCSI Devices Enabled (checked)

Allow Multiple paths to SCSI Targets Enabled (checked)

Use Report LUNs Enabled (checked)

Other Parameters

Maximum Number of LUNs

Refer to “ELXCFG.EXE”, “Versions” on page 195

Maximum Queue Depth Refer to “ELXCFG.EXE”, “Versions” on page 195

Wait Ready Timer Refer to “ELXCFG.EXE”, “Versions” on page 195

Link Down Timer Refer to “ELXCFG.EXE”, “Versions” on page 195

E_D_TOV 2000 ms

R_A_TOV 2 sec

AL_TOV 15 ms

ARB_TOV 1000 ms

1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 239 240

Keine Kommentare

Emulex 110 Installationsanleitung Seite 208