Emulex 110 Installationsanleitung PDF herunterladen (Seite 28)

EMC Host Connecivity with Emulex Fibre Channel HBAs and CNAs in the Windows Environment

Installation and Configuration

Note that a few adapters are keyed universally, but require 5 V power

(LP7000, LP8000, LP850.) They will fit into a 3.3 V PCI/PCI-X slot, but

will not work unless the slot is capable of universal (3.3 V and 5 V)

signaling. Consult your server user guide or manufacturer.

The LP9802DC, while capable of 3.3 V or 5 V signaling operation, fits

only into a 3.3 V PCI/PCI-X slot. Remember, some of the older

adapters are tall (also referred to as full-height) and may not fit into a

server with a low-profile chassis. These factors must be considered

before implementing your configuration to avoid unnecessary delays

and possible equipment swaps or returns.

Note: The Emulex LP2100x FCoE CNAs require servers that can

accommodate full-height, full-length PCI Express adapters. Always refer to

the EMC Support Matrix for the most up-to-date information on which

servers support these adapters.

LP1150/LP11000/LP11002 FC PCI-X 2.0 & PCI 3.0 64-bit 3.3v 3.3v

LPe1150/LPe11000/LPe11002 FC PCI Express x4 lane 3.3v n/a

LPe1250 FC PCI Express x4 lane 3.3v n/a

LPe12000 FC PCI Express x4 lane 3.3v n/a

LPe12002 FC PCI Express x4 lane 3.3v n/a

LPe16000B / LPe16002B FC PCI Express x8 lane 3.3v n/a

LP21000 FCoE PCI Express x8 lane 3.3v n/a

LP21002 FCoE PCI Express x8 lane 3.3v n/a

Table 1 Slot requirements of EMC-supported Emulex adapters (page 2 of 2)

Adapter model Protocol PCI spec BUS length Power Slot key

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 239 240

Keine Kommentare

Emulex 110 Installationsanleitung Seite 28