Emulex 110 Installationsanleitung PDF herunterladen (Seite 152)

152

EMC Host Connecivity with Emulex Fibre Channel HBAs and CNAs in the Windows Environment

Installation and Configuration

Figure 131 Scanning for available boot LUNs

If no entries (other than 00) appear, verify the following:

• If multiple adapters are present, verify the adapter selected in

the BIOS utility is the same adapter that currently provides the

I/O path to the storage. (At this point, only one I/O path

should be configured to the boot LUN.)

• For VNX series or CLARiiON systems, verify the single I/O

path points to the SP that owns the boot LUN.

• For FC-SW environments, verify fabric-zoning parameters,

such that a single I/O path exists to the boot LUN. (Refer to

your array software documentation for details.)

• Check the physical Fibre Channel connectivity between the

adapter and array switch (FC-SW environment).

9. Enter the two digits of the starting LUN address, and press Enter.

This setting specifies the LUN address where the utility will begin

scanning for available boot LUNs. For example, entering 0B will

result in the utility scanning from LUN address 0B for available

LUNs, skipping addresses 00 through 0A. In this example,

entering 00 instructs the utility to scan from 00, which is the first

LUN address. This will scan all LUNs visible to the adapter.

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 239 240

Keine Kommentare

Emulex 110 Installationsanleitung Seite 152