Emulex LP21000 Bedienungsanleitung PDF herunterladen (Seite 127)

The OneCommand Manager User Manual Page 117

To configure DCB for iSCSI adapter ports:

1. From the discovery-tree, select the iSCSI adapter port whose CEE properties you want to

configure.

2. Select the DCB tab.

3. Click Configure DCB. The Configure DCB dialog box appears.

4. Configure the settings you want and click OK.

Figure 67: Configure DCB dialog box for iSCSI adapter ports (DCBX enabled)

Configure DCB Dialog Box Field Definitions

DCBX Settings Area

• Enabled - DCBX can be enabled or disabled. With DCBX enabled, the configured values are

used only if the switch does not provide them. With DCBX disabled, the configured values are

used. Changes to the DCBX state require a reboot of the host.

• DCBX Mode - The DCBX mode can be set to CEE or CIN. Changes to the DCBX mode require

a reboot of the host.

• Operating Version - The operating version of the DCBX protocol. The system adjusts as needed

to operate at the highest version supported by both link partners. This setting cannot be

changed.

Note: An error message is displayed if you try to configure more priority groups than the

adapter supports. The “Max Configurable PGs” field shows the number of priority

groups supported by the adapter.

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 273 274

Keine Kommentare

Emulex LP21000 Bedienungsanleitung Seite 127