Emulex LP9802DC Bedienungsanleitung PDF herunterladen (Seite 22)

Install the Driver

To install the driver and boot the system, follow these instructions. While it is possible to

install lpfc onto one or more clients from a server, that procedure is not covered here; refer

to your HP-UX system administration documentation for that procedure. If a prior version

of the lpfc device driver is already installed on the system, you must first remove the old

driver.

Note

A new adapCfg.h file is copied into the opt/lpfc/conf/

directory during installation. If this driver was previously

installed and you have configuration changes you wish to

save, copy the original opt/lpfc/conf/adapCfg.h file to a safe

place and transfer any edits from the old file to the new file

after installation.

1. Login as or su to root.

2. Load the depot file from your distribution medium into a directory, referred to here

as <where-you-put-it>. The depot file name is lpfc.depot.

3. At the shell prompt, type:

cd <where-you-put-it>

swinstall -s `pwd`/lpfc.depot -x autoreboot=true LPFC

The system will reboot automatically, and the lpfc driver will be included in the HP-

UX kernel.

4. Before you proceed, decide whether you must change any driver configuration

parameter, beyond the defaults established by the installation process.

Emulex Documentation, Drivers, and Software

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 68 69

Keine Kommentare

Emulex LP9802DC Bedienungsanleitung Seite 22