Emulex ONECONNECT OCE10102-F Betriebsanweisung PDF herunterladen (Seite 29)

8 Select [Reboot System] and press the [Enter] key.

Exit Fast!UTIL

Reboot System

Return to Fast!UTIL

The server reboots.

To return to the [Fast!UTIL] menu, select [Return to Fast!UTIL].

2.2.4 Installing VMware ESX

•

VMware ESX should be installed now if it has not yet been installed in the server. Refer to the following

URL for details.

http://www.vmware.com/support/pubs/

•

If SAN Boot is used, use the QLogic "Fast!UTIL" tool to check the Fibre Channel path in the Converged Net-

work Adapter card BIOS.

The Fibre Channel path can be checked on the server BIOS screen after the Fibre Channel switch and the

CEE/FCoE switch settings are completed.

The checking procedure is as follows:

1 Turn on the server, and press the [Ctrl] + [Q] keys while the following message is displayed.

The "Fast!UTIL" program starts up (Startup may take longer than usual).

QLE8142 PCI Fibre Channel ROM BIOS Version 3.00 - Beta 14

www.qlogic.com

Press <CTRL-Q> or <ALT-Q> for Fast!UTIL

Firmware Version 5.04.01

2 When there are two or more FCoE ports for the Converged Network Adapter card, select the appropriate

port.

3 Select [Scan Fibre Devices] from the [Fast!UTIL Options] menu.

The ETERNUS DX

storage systems should appear.

If the ETERNUS DX storage systems appear, the settings were performed successfully. If the ETERNUS DX stor-

age systems do not appear, recheck the setup procedures given in this manual, the ETERNUSmgr installation

and settings, or the Fibre Channel switch and CEE/FCoE switch settings.

Chapter 2 Setup Procedure for QLogic Converged Network Adapter Cards

2.2 Setting Up the Converged Network Adapter Cards

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-

(FCoE) for VMware

ESX

P3AM-4772-10ENZ0

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

Keine Kommentare

Emulex ONECONNECT OCE10102-F Betriebsanweisung Seite 29