Emulex ONECONNECT OCE10102-F Installationsanleitung PDF herunterladen (Seite 5)

Fujitsu OneConnect OCe10102 CNA Installation Manual - Hardware Page 5

Prerequisites

• PCI Express 2.0 compliant systems: x8 or x16 lane transfer link interface at up to 5 Gb/s per

lane.

CNA Identification

Each CNA is shipped with several numbers clearly marked on the board Including:

• The IEEE Address

• The World Wide Name (wwn)

• The serial number

• The IEEE address is a unique 64-bit identifier that you use when configuring your system. The

FC industry uses the World Wide Name (wwn) derived from the IEEE address for FC

connectivity. If the adapter has two ports, it has two IEEE addresses and two wwns, one for each

port. Use the serial number when communicating with Emulex. Record these numbers before

installation.

Installing the Adapter

1. Turn off and unplug the computer.

2. Remove the computer case.

3. Remove the blank panel from an empty PCIe bus slot. See “Attaching Media” on page 6.

4. Insert the CNA into the empty x8 or x16 PCIe bus slot. Press firmly until the adapter is seated.

5. Secure the CNA's mounting bracket to the case with panel screw or clip.

6. Replace the computer case and tighten case screws.

The CNA is now installed in the server and is ready for media attachment.

Note: Place the CNA into an empty PCIe x8 or x16 slot. Make sure that the adapter is in an

appropriate PCIe slot that does not interfere with other components or case to

prevent damage to the CNA.

1 2 3 4 5 6 7 8 9 10 11 12 13

Keine Kommentare

Emulex ONECONNECT OCE10102-F Installationsanleitung Seite 5